null

SPX External Model-Adhesive Handlebar Grip Heater Kit

No Reviews yet Write a Review
$70.69
$72.95
(You save $2.26 )

In Stock

SKU: 12-170
Thank you! You will be notified by email once this product is in stock.
We are unable to process your request at this time. Please try again later.
  • Low Price Guarantee
  • Easy Returns
  • Fast Shipping

Product Details

Features

  • Enjoy those long winter rides without a worry
  • Effectively keeps hands warm and dry
  • Requires drilling

INSTALLATION INSTRUCTIONS:

STEP 1 –Remove grips If you have rubber grips heat them until they become flexible  Break the mastic by inserting a Phillips screw-driver between grip and handlebar. Then pry grip straight off. Do not attempt to twist off grip.

STEP 2 –Remove all residue (glue  rubber etc ) from area covered by grip on handlebar Clean properly using either fine sandpaper or gasoline to obtain a residue free surface, ready to receive the heating element.

STEP 3 –Remove white contact protector from heating element. Encircle cleaned area with heating element, replace rubber grip on each side. Attach wires along control wire to pass underneath the hood.

STEP 4 –Drill a 1/2” dia. hole in dashboard for the installation of the HI-OFF-LO switch.

STEP 5 –Take the wire from the heating element which is not connected to the switch and attach it to a suitable ground

  • a) Electric Start Models: Taka a length of 18 gauge stranded wire and connect it to the end of the single wire which extends from the “Y” junction and connect it to the accessory lug on the rear of

the the snowmobile ignition switch.

  • b) Manual Start Models: The wire mentioned in 5a) must be connected to magneto (yellow wire) +

STEP 6 –Choose the switch position for the desired function: 

  • 1) Up position for high heat
  • 2) Centre off:
  • 3) Down position for low heat
  • NOTE: The lead on which the resistor is installed should be connected to the terminal which is located in front of the slot on the threaded portion of the switch in order to match the HI-OFF-LO switch.

STEP 7 –Fasten wiring to steering column with electrical tape or a nylon tie wrap.

  • NOTE: Installation instructions supplied with each kit
Fast and free shipping
Fast and free shipping

To most locations on orders over $99.

EVERYDAY LOW PRICES
EVERYDAY LOW PRICES

Top brands, lowest prices.

#1 IN CUSTOMER SERVICE
#1 IN CUSTOMER SERVICE

Expert knowledge and outstanding service.